Reset and Reboot Procedures
Have you tried turning the device off and on again?
Sometimes all that is needed is a reboot. This can be done for the skaarOS / the full Blue Pill / or per package.
Blue Pill Reboot
On the Settings page, click the Reboot button in the System Information section. This will restart the entire unit.
Package Restart
You can restart an individual package on the Packages page. Click on the status of the package (being Running or Stopped) to be restarted.
Then click 'Restart' in the pop-up.
Reactor > Clear config directory
If a configuration has crashed Reactor, and you can only access the 'Packages' and 'Settings' pages, you may need to erase the content of the cofiguration directory.
Note: This will ERASE ALL CONFIGURATIONS on the device. |
On the Packages pages, click 'Reactor'. Then click 'Clear config directory'. Finally click 'Confirm and restart'.
Factory Reset
If you think you really messed up the Blue Pill in some way, you can do a full Factory Reset of the unit.
Note: This will ERASE EVERYTHING you have done on the Blue Pill device. |
In the System Information section there is a Reset button. Press it and follow the prompts.
You can even hold down [Shift] on you keyboard and press 'Reset'. This will initiate 'Hard System Reset'.
No access to Reactor webpage
If you are not able to access Reactor webpage at all, then you have two options:
- Press paperclip into 'Config Button' hole on back of device > hold it for 5 secs.
This will reset IP address to DHCP - and enable the Wifi module, allowing you to access it using a wireless connection. Please read the wiki 'Accessing Blue Pill > Wi-Fi Access Point' for this: https://wiki.skaarhoj.com/books/blue-pill-reactor/page/accessing-blue-pill-1be - Do a complete Reflash of the software.
This will replace the entire software-image-file. A guide is provided in this article: https://wiki.skaarhoj.com/books/blue-pill-reactor/page/reflash-blue-pill-devices